Zhermack Zetaplus Soft Putty

Polysiloxane (condensation silicone) This soft to mix, with elastic setting putty is suitable for any clinical situation and is particularly recommended for the single-stage technique.

APPLICATION :-

Zetaplus: Polysiloxane for the first impression characterised by initial flow in the working phase and high rigidity after hardening. Recommended for the two stage technique (double impression)

Zetaplus Soft: Polysiloxane for the first impression characterised by initial flow in the working phase and adequate elasticity on removal from the oral cavity. Recommended for the two stage technique (double impression)

Oranwash VL: Low viscosity, extremely fluid, hydrocompatible, polysiloxane. Recommended for the two stage technique (double impression)

Oranwash L: Low viscosity, extremely fluid, hydrocompatible, polysiloxane. Recommended for the two stage technique (double impression)

Thixoflex M: Low viscosity, thixotropic, hydrocompatible, polysiloxane. It does not drip when injected directly onto the preparation, yet flows easily. Recommended for the two stage technique (double impression) and a single phase (simultaneous) and for the relining of removable prosthesis.

• Excellent relation between rigidity and elasticity
• Ideal working time/setting time ratio
• High flowability and accuracy of wash materials
• Putty and wash materials with the same catalys

TECHNICAL SPECIFICATIONS:

Packaging:-

• 1 900 ml tub 900 ml (1.53 kg)
• 1 x 140 ml Oranwash VL
• 1 x 60 ml Indurent Gel

Dosage :

• Use the measuring spoon to dose the required quantity of Zetaplus and spread it out over your hand (note: for the correct dosage the putty should be level with the top of the measuring scoop). Press the rim of the measuring scoop onto the putty once for each measure dosed. For each measure of material, apply two strips of Zhermack Indurent Gel as long the measuring scoop (4 cm.)
• When using Zhermack Indurent Liquid, dose 5 – 6 drops of hardening liquid for each scoop of putty used.

Mixing :

• Fold and knead the putty energetically with your fingertips for about 30 sec., until the colour is even, without any stripes
• Spread out the putty over the impression tray. The working time including mixing time is about 1 min. 15 sec.
• Put into the mouth and wait until it is set, which will take about 3 min. 15 sec.